SKIN TRANSPARENT installation instructions

Before you start installing the skin, switch off your device and remove the battery (if this is possible and the battery is not built in).

STEP 1
Wash your hands and fingertips thoroughly. We recommend applying the skin in a place with clean air and not too much dust (bathroom, kitchen)
STEP 2
To avoid leaving fingerprints on the skin, we recommend keeping your fingertips moist with the solution from the pack throughout the installation. You also need to wipe the phone very thoroughly and remove all dust particles.
STEP 3
Peel the skin off its backing and identify the cut-outs (for the camera, speaker and buttons)
STEP 4
Spray the installation solution onto the adhesive side of the skin. The skin stops being sticky for about 5 minutes, during which time you can position it precisely on the device. 
STEP 5
Apply the skin to the device, adhesive side down, finding its perfect position
STEP 6
We recommend using a cloth over the applicator card for the application. Use the applicator card together with the cloth from the package to push out the liquid and bubbles, working from the centre towards the edges of the device.

Press each area of the skin onto the curved edge with the heel of your hand for 5 seconds, until it sticks. If the skin doesn’t stick in some areas, repeat the process after a 10-minute break.
STEP 7
Wipe the excess liquid off the device with the cloth

IMPORTANT
When you remove the excess liquid, it runs down to the edges, making them non-adhesive for about 30 minutes. You need to wait until the skin adheres to the curved edge, then keep pressing with the heel of your hand until the skin sticks completely.
After application, keep use of the device to a minimum and don’t put it in your pocket for 8 hours, as this is the time the skin needs to set firmly. Liquid bubbles and small imperfections left after application disappear within 24–48 hours.